Skip to content
SmartFACT HelpHandbooksWatch and practise
Handbooks: RefillFlow

How to set a due time for one receiving location

Use a starter rule to give every request for one receiving location its own working-time due target.

Review edition · 13 November 2026 · For Author, Reviewer

On this page

Some lines cannot wait as long as the rest, such as a press that stops when its sealant runs out. The starter rule A due time for one receiving location adds one rule that gives every request going to one receiving location its own working-time due target.

Use the starter rule

You need the Author or Reviewer role at the site, and a saved draft: the card copies the draft's default outcome.

  1. Open Rules and releases. Starter rules comes before the draft.
  2. Find A due time for one receiving location, under Due times and chasing.
  3. Fill in the blanks in the card's sentence, "Requests for … are due within … working minutes.":
    • Receiving location: one of this site's receiving locations.
    • Working minutes: 1 to 10,080; the card starts at 60.
  4. Choose Use this rule.

What is added

The draft gains a new revision with one rule after every rule it already has. It matches requests whose receiving location is yours. Its outcome is the draft's default outcome with your due time: the same stores queue, priority and urgency approval.

The due time counts working minutes from the request in the site's working calendar, and the stores board shows each refill's due time. A rule that keeps the default queue and names no escalation can run on Free, within its three rules.

Check the examples

A card saves no example. After the card, the page offers examples prepared from this site's loops at that location, each expecting the new rule to decide it. Choose Add the prepared examples, check them, then choose Save draft.

Release it

Choose Prove the saved draft, read the review and have a reviewer activate it; see rules and releases.

If the card is refused

  • The card has changed since the page was read, or the location was retired. Choose it again.
  • The draft already has a rule that tests exactly this. Change that rule instead.
  • Save the draft with its default outcome first.

Nothing was added after any of these. You can change or remove the rule in any later release.

Arriving from SmartFACT Automation

Where SmartFACT Automation is connected, choosing Use this rule on this card there brings you to Rules and releases with the card filled in. Nothing is added until you choose Use this rule here.