Skip to content
SmartFACT HelpHandbooksWatch and practise
Handbooks: RefillFlow

How to send one family to its own stores queue

Use a starter rule to send every request for one item family to the stores queue you choose.

Review edition · 13 November 2026 · For Author, Reviewer

On this page

When one kind of material always comes from its own part of stores, such as chemicals from a chemical store, its requests should go straight to that stores queue. The starter rule Send one family to its own queue adds one rule that sends every request for one item family to the stores queue you choose, wherever it is going.

Use the starter rule

You need the Author or Reviewer role at the site, and a saved draft: the card copies the draft's default outcome.

  1. Open Rules and releases. Starter rules comes before the draft.
  2. Find Send one family to its own queue, under Where requests go.
  3. Fill in the blanks in the card's sentence, "Send every request for … to ….":
    • Item family: one of this site's item families.
    • Stores queue: one of this site's enabled stores queues.
  4. Choose Use this rule.

What is added

The draft gains a new revision with one rule after every rule it already has. It matches your item family. Its outcome is the draft's default outcome with your stores queue, whose tickets print by the queue's own approved print mapping. Other requests keep the default outcome.

Every loop of that family must allow your stores queue: the card is refused, naming the loops, where one does not. On Free, a rule keeps the default queue; Pro allows another approved queue. The review's What the plan must allow says what the release needs.

Check the examples

A card saves no example. After the card, the page offers examples prepared from this site's loops for that family, each expecting the new rule to decide it. Choose Add the prepared examples, check them, then choose Save draft.

Release it

Choose Prove the saved draft, read the review and have a reviewer activate it; see rules and releases.

If the card is refused

  • A loop the card names may not be supplied by that stores queue. Allow the queue on each loop first, or choose another queue.
  • The draft already has a rule that tests exactly this. Change that rule instead.
  • The card has changed since the page was read. Choose it again.

Nothing was added after any of these. You can change or remove the rule in any later release.

Arriving from SmartFACT Automation

Where SmartFACT Automation is connected, choosing Use this rule on this card there brings you to Rules and releases with the card filled in. Nothing is added until you choose Use this rule here.