Skip to content
SmartFACT HelpHandbooksWatch and practise
Handbooks: RefillFlow

How to escalate unaccepted requests for one location

Use a starter rule to give the supervisors a task when a request for one location is not accepted in time.

Review edition · 13 November 2026 · For Author, Reviewer

On this page

A request for a line that is about to stop should not sit unaccepted on the stores board. The starter rule Escalate unaccepted requests for one location adds one rule and one escalation policy that give the supervisors a task when nobody in stores accepts a request for one receiving location within the time you choose.

Use the starter rule

You need the Author or Reviewer role at the site, and a saved draft: the card copies the draft's default outcome.

  1. Open Rules and releases. Starter rules comes before the draft.
  2. Find Escalate unaccepted requests for one location, under Due times and chasing.
  3. Fill in the blanks in the card's sentence, "Give the supervisors a task when a request for … is not accepted within … working minutes.":
    • Receiving location: one of this site's receiving locations.
    • Working minutes: 1 to 10,080; the card starts at 30.
  4. Choose Use this rule.

What is added

The draft gains a new revision, saved exactly as you would save it by hand:

  • An escalation policy named "Not accepted within 30 working minutes: supervisors", with one stage: while the refill is not accepted, a task for the supervisors at your time after the request.
  • A rule after every rule the draft already has. It matches requests whose receiving location is yours. Its outcome is the draft's default outcome with the new policy.

Accepting the refill settles the task, and closing the refill resolves it. A task never changes the refill, its queue or its quantity. On Free, a rule names no escalation; Pro allows it. The review's What the plan must allow says what the release needs.

Check the examples

A card saves no example. After the card, the page offers examples prepared from this site's loops at that location, each expecting the new rule to decide it. Choose Add the prepared examples, check them, then choose Save draft.

Release it

Choose Prove the saved draft, read the review and have a reviewer activate it; see rules and releases and working calendar and tasks.

If the card is refused

  • The card has changed since the page was read, or the location was retired. Choose it again.
  • The draft already has a rule that tests exactly this. Change that rule instead.
  • A draft holds at most 20 escalation policies. Remove one you no longer use first.

Nothing was added after any of these. You can change or remove the rule and its policy in any later release.

Arriving from SmartFACT Automation

Where SmartFACT Automation is connected, choosing Use this rule on this card there brings you to Rules and releases with the card filled in. Nothing is added until you choose Use this rule here.