Skip to content
SmartFACT HelpHandbooksWatch and practise
Handbooks: OrderRun

When FactorySpec refuses a unit

Read FactorySpec's reasons on a held order, put them right and ask again.

Review edition · 16 November 2026 · For Supervisor

On this page

When FactorySpec refuses a unit, OrderRun holds the order with FactorySpec's reasons, and the release that was being prepared cannot go ahead. This happens when FactorySpec's active release says no to the unit's inputs, or when OrderRun asked under a release that is no longer FactorySpec's active one.

Read the hold

Open the order. The hold names the unit and each of FactorySpec's reasons, with the FactorySpec input it concerns and the order field that input came from, for example a width outside the family's approved range, taken from the order's width.

Put it right

  • If the order's value is wrong, correct it upstream so a new revision of the order arrives, and prepare the release again.
  • If FactorySpec's active release has changed, the Owner updates the set-up under Site, Engineering results, and a Supervisor reviews it.
  • Then a Supervisor asks FactorySpec again for the unit. A current result for it clears the hold by itself.

A Supervisor may also resolve the hold with a reason, as for a hold a person placed. Manual engineering evidence never clears a FactorySpec refusal by itself.

When FactorySpec withdraws a result

If FactorySpec later withdraws a result OrderRun was given, OrderRun stops counting it at once and any release prepared on it must be prepared again. If the unit was already issued and not despatched, its pack needs reconciling and the order is held, as for withdrawn evidence.