Skip to content
SmartFACT HelpHandbooksWatch and practise
Handbooks: StoresFlow

Connect RefillFlow to a stockroom

Connect a suite product that asks for stock, map its items in the same unit, and pause or disconnect it.

Review edition · 18 November 2026 · For Owner

On this page

RefillFlow keeps lines and workstations topped up. When your organisation has both products, an Owner can connect RefillFlow to one StoresFlow stockroom, so that a refill requested at the line arrives here as a demand that stores reserve, pick and issue. Nothing is sent, and no request arrives here, until the installation is set up for requests, the Owner here connects RefillFlow, and the Owner in RefillFlow switches the link on there. RemnantRack connects the same way, for a new length taken for a job: see Connect RemnantRack to a stockroom.

Connect

As Owner, open Connections. Under Requests for stock, choose RefillFlow. If the page says requests are not switched on for this installation, your administrator registers RefillFlow first. If it says this organisation does not have RefillFlow, the product is not enabled for you in SmartFACT Accounts.

Under Connect RefillFlow, choose the Stockroom its requests draw from, set Hold reserved stock for (minutes) (1,440 is one day), give a Reason for this change and choose Connect RefillFlow. A recent second factor is needed. The connection appears in History with your name and reason.

Map the items

RefillFlow lists the items it may ask for under Items. Each one needs a StoresFlow item with exactly the same unit: a bag is mapped to an item held in bags, never converted. Write a Reason for mapping changes once, then:

  • where StoresFlow has an active item with the same code and unit, choose Map to that item;
  • otherwise use Find a StoresFlow item, choose the item, and map it;
  • for an item RefillFlow has not listed yet, enter its code and unit under Map an item RefillFlow has not listed.

An item that is not mapped stays supplied by RefillFlow itself. Remove mapping stops new requests for that item; requests already open keep the item they were accepted with. A mapping marked Needs review points to an item that is no longer active: map the RefillFlow item again to the right one.

Each StoresFlow item mapped for RemnantRack is held in whole units, with the Length of one unit, such as 6000 mm or 6 m.

Where pick documents print

RefillFlow's Owner chooses whether a refill's paper is RefillFlow's own ticket or StoresFlow's pick document. For StoresFlow's, choose where it prints under Pick documents: Show PrintStation destinations, choose a destination, give a reason and choose Print pick documents at that destination. It prints on that destination's paper, 6 x 4 inch labels or A4, as the sales channels' pick tickets do. A recent second factor is needed. Without a destination nothing prints by itself, and stores print the document from the Requests page with Print here.

Pause or disconnect

Under Change the connection, choose Paused while stores cannot take new requests, for example during a stocktake: RefillFlow keeps its requests and sends them again later. Choose Disconnected to stop new requests for good; RefillFlow then supplies its items itself again. Either way, requests already open are worked and reported back. You can also change the stockroom or the hold time here. To connect again after a disconnection, use Connect RefillFlow: the mappings are kept.

The Owner does not see stock on these pages: only item codes, names and units.