# Reserve a released component

Take a station, scan a released part and reserve it for a named destination.

Source: https://help.smartfact.ai/reclaimstation/guides/reclaimstation-operator-reserve-part

Audience: Operator

Work as Sam at the recovery bench. Follow the recorded controls and check the physical component before each action.

## Reserve a released component

1. **Choose the recovery bench**

   Choose the recovery bench.

   Choose the named bench where you are doing the work.

2. **Use the named station**

   Use the named station.

   Use your own sign-in to take control of the bench. This does not reserve or release any part.

3. **Ready the scanner**

   Ready the scanner.

   Put the scanner input in focus before reading the label on the actual part.

4. **Scan the power module**

   Scan the power module.

   Scan P M zero four eight seven. Check the part and revision against the physical module.

5. **Choose its destination work**

   Choose its destination work.

   Choose the requirement for Build five eight two one. Check the destination slot and required revision.

6. **Check and reserve the part**

   Check and reserve the part.

   The server checks current permission, release, holds and the approved reuse policy. A reservation sets the part aside; fitting is a separate step.

[Watch or practise this chapter](https://help.smartfact.ai/reclaimstation/demo?guide=reclaimstation-operator-reserve-part&chapter=reserve-part)

A reservation is not fitting or release. Start installation only for the actual reserved part and destination, and confirm it only after fitting.