Reserve a released component
Take a station, scan a released part and reserve it for a named destination.
For operators
Work as Sam at the recovery bench. Follow the recorded controls and check the physical component before each action.
Read these instructions on any device. Watch or practise a chapter on a desktop or laptop, with a desktop or mobile application layout. Demonstrations use sample data and simulated scanners.
Reserve a released component
- Choose the recovery bench
Choose the recovery bench.
Choose the named bench where you are doing the work.
- Use the named station
Use the named station.
Use your own sign-in to take control of the bench. This does not reserve or release any part.
- Ready the scanner
Ready the scanner.
Put the scanner input in focus before reading the label on the actual part.
- Scan the power module
Scan the power module.
Scan P M zero four eight seven. Check the part and revision against the physical module.
- Choose its destination work
Choose its destination work.
Choose the requirement for Build five eight two one. Check the destination slot and required revision.
- Check and reserve the part
Check and reserve the part.
The server checks current permission, release, holds and the approved reuse policy. A reservation sets the part aside; fitting is a separate step.
A reservation is not fitting or release. Start installation only for the actual reserved part and destination, and confirm it only after fitting.