# Install a part in a unit

Reserve a released part, check both identities, start the fitting and confirm it once the part is in place.

Source: https://help.smartfact.ai/reclaimstation/guides/reclaimstation-operator-install-part

Audience: Operator

Work as Sam at the recovery bench. Check the physical module and the unit at every step.

## Install a part in a unit

1. **Choose the recovery bench**

   Choose the recovery bench.

   Choose the named bench where you are doing the work.

2. **Use the named station**

   Use the named station.

   Use your own sign-in to take control of the bench. This does not reserve or release any part.

3. **Ready the scanner**

   Ready the scanner.

   Put the scanner input in focus before reading the label on the actual part.

4. **Scan the power module**

   Scan the power module.

   Scan P M zero four eight seven. Check the part and revision against the physical module.

5. **Choose its destination work**

   Choose its destination work.

   Choose the requirement for Build five eight two one. Check the destination slot and required revision.

6. **Check and reserve the part**

   Check and reserve the part.

   The server checks current permission, release, holds and the approved reuse policy. A reservation sets the part aside; fitting is a separate step.

7. **Open Install a part**

   Open Install a part.

   Open Install a part from the menu.

8. **Choose the reservation**

   Choose the reservation.

   Choose the reservation for Build five eight two one.

9. **Scan the module**

   Scan the module.

   Scan the module in your hand, P M zero four eight seven.

10. **Scan the destination unit**

   Scan the destination unit.

   Scan the unit it goes into, Build five eight two one. Both identities must match the reservation.

11. **Start the installation**

   Start the installation.

   Start the installation when you are ready to fit this exact part. The checks run again.

12. **Choose the started installation**

   Choose the started installation.

   Fit the module, then choose the installation you started.

13. **Confirm the fitting**

   Confirm the fitting.

   Confirm that this exact module is fitted in the recorded unit and slot.

14. **Confirm it is installed**

   Confirm it is installed.

   The module is recorded as installed in Build five eight two one, in the power slot.

15. **Open the menu**

   Open the menu.

   Open the menu to look at the record.

16. **Show the office pages**

   Show the office pages.

   Switch the menu to the office pages, where the records are.

17. **Open Components**

   Open Components.

18. **Search for the serial**

   Search for the serial.

   Search the complete register for P M zero four eight seven.

19. **Run the search**

   Run the search.

   Only the matching module is listed.

20. **Open the module's record**

   Open the module's record.

   Its installation history now names Build five eight two one, so the unit it went into can be found later.

[Watch or practise this chapter](https://help.smartfact.ai/reclaimstation/demo?guide=reclaimstation-operator-install-part&chapter=install-part)

The installation is now part of the module's history, so the unit it went into can be found if a problem turns up later.