Install a part in a unit
Reserve a released part, check both identities, start the fitting and confirm it once the part is in place.
For operators
Work as Sam at the recovery bench. Check the physical module and the unit at every step.
Read these instructions on any device. Watch or practise a chapter on a desktop or laptop, with a desktop or mobile application layout. Demonstrations use sample data and simulated scanners.
Install a part in a unit
- Choose the recovery bench
Choose the recovery bench.
Choose the named bench where you are doing the work.
- Use the named station
Use the named station.
Use your own sign-in to take control of the bench. This does not reserve or release any part.
- Ready the scanner
Ready the scanner.
Put the scanner input in focus before reading the label on the actual part.
- Scan the power module
Scan the power module.
Scan P M zero four eight seven. Check the part and revision against the physical module.
- Choose its destination work
Choose its destination work.
Choose the requirement for Build five eight two one. Check the destination slot and required revision.
- Check and reserve the part
Check and reserve the part.
The server checks current permission, release, holds and the approved reuse policy. A reservation sets the part aside; fitting is a separate step.
- Open Install a part
Open Install a part.
Open Install a part from the menu.
- Choose the reservation
Choose the reservation.
Choose the reservation for Build five eight two one.
- Scan the module
Scan the module.
Scan the module in your hand, P M zero four eight seven.
- Scan the destination unit
Scan the destination unit.
Scan the unit it goes into, Build five eight two one. Both identities must match the reservation.
- Start the installation
Start the installation.
Start the installation when you are ready to fit this exact part. The checks run again.
- Choose the started installation
Choose the started installation.
Fit the module, then choose the installation you started.
- Confirm the fitting
Confirm the fitting.
Confirm that this exact module is fitted in the recorded unit and slot.
- Confirm it is installed
Confirm it is installed.
The module is recorded as installed in Build five eight two one, in the power slot.
- Open the menu
Open the menu.
Open the menu to look at the record.
- Show the office pages
Show the office pages.
Switch the menu to the office pages, where the records are.
- Open Components
Open Components.
- Search for the serial
Search for the serial.
Search the complete register for P M zero four eight seven.
- Run the search
Run the search.
Only the matching module is listed.
- Open the module's record
Open the module's record.
Its installation history now names Build five eight two one, so the unit it went into can be found later.
The installation is now part of the module's history, so the unit it went into can be found if a problem turns up later.