Handle a held component
See why an unreleased component cannot be reserved and keep it out of use.
For operators
Work as Sam at the recovery bench. Follow the recorded controls and check the physical component before each action.
Read these instructions on any device. Watch or practise a chapter on a desktop or laptop, with a desktop or mobile application layout. Demonstrations use sample data and simulated scanners.
Handle a held component
- Choose the recovery bench
Choose the recovery bench.
Choose the named bench where you are doing the work.
- Use the named station
Use the named station.
Use your own sign-in to take control of the bench. This does not reserve or release any part.
- Choose the held cover
Choose the held cover.
The cover is still waiting for checks and independent release. Its location alone cannot make it available.
- Choose its destination work
Choose its destination work.
Choose the requirement for Build five eight two one. Check the destination slot and required revision.
- Keep an unreleased part out of use
Keep an unreleased part out of use.
The request is refused. Keep the part held and ask a supervisor to review what is missing. Do not use a different label to bypass the check.
A reservation is not fitting or release. Start installation only for the actual reserved part and destination, and confirm it only after fitting.