Handle measurements that need attention

Recognise an outside-tolerance result and refuse an invalid measurement, read the likely cause, then print again after one change and measure the new label.

For operators

Recognise an outside-tolerance result and refuse an invalid measurement, read the likely cause, then print again after one change and measure the new label.

Read these instructions on any device. Watch or practise a chapter on a desktop or laptop, with a desktop or mobile application layout. Demonstrations use sample data and simulated scanners.

Handle measurements that need attention

  1. Record a width outside tolerance

    Record a width outside tolerance.

    The width is 3% short, outside tolerance. PrintBench asks for the height too: a shrink in both directions points to the page being scaled, one direction alone to the feed.

  2. Refuse a negative measurement

    Refuse a negative measurement.

    A negative measurement cannot be used. Correct it from the paper label rather than accepting an invalid result.

  3. Record a height short by the same amount

    Record a height short by the same amount.

    The height is short by the same amount. A similar shrink in both directions is what Fit to page does, so PrintBench names that cause first, with the setting to change.

  4. Choose the one change to make

    Choose the one change to make.

    Choose the one change you will make before printing again. Here it is the suggested one: print at actual size, with Fit to page turned off.

  5. Print the same sheet again

    Print the same sheet again.

    Make that change, then print the same sheet again. A new check opens at the print step and the first check stays in the report as it was.

  6. Record that the label printed

    Record that the label printed.

    For practice, record that our example label is available. In a real check, choose this only after you have the paper label.

  7. Confirm the sheet name printed on the label

    Confirm the sheet name printed on the label.

    Check the sheet name and version printed on the label. All the test sheets carry the same barcode values, so a matching scan cannot identify the sheet.

  8. Go on to measure, scan and report

    Go on to measure, scan and report.

    Once what came out is recorded, the last step opens. A printed label is measured and scanned there; without one, the report still records what happened.

  9. Record the width measurement

    Record the width measurement.

    Enter 50.05 millimetres for this practice example. On a real label, measure between the tick centres on paper, not on the screen.

  10. Measure the new label's height

    Measure the new label's height.

    Measured again, both directions are within tolerance, and PrintBench says it is after the change. The report keeps both checks, so it shows what the change did.

  11. Review the report

    Review the report.

    Review the evidence before sharing it. By default, device names, notes and received text are excluded.

Watch or practise this chapter

Use real paper measurements and keep useful evidence. This training does not qualify physical equipment.

Contact SmartFACT support · Explore the suite