# Connect RemnantRack to a stockroom

Connect RemnantRack for new lengths taken for jobs, map each material to an item held in whole bars with the length of one bar, and pause or disconnect it.

Source: https://help.smartfact.ai/manuals/storesflow/connect-remnantrack

Review edition: 18 November 2026

Roles: owner

RemnantRack keeps track of offcuts: lengths left over from a cut, measured and labelled in a rack. When no offcut fits a job, the person in RemnantRack can take a new length from your stock. When your organisation has both products, an Owner can connect RemnantRack to one StoresFlow stockroom, so that such an ask arrives here as a demand for one length that stores reserve, pick and issue. Nothing is sent, and no ask arrives here, until the installation is set up for requests, the Owner here connects RemnantRack and maps its materials, and the Owner in RemnantRack switches the link on there.

## Connect

As Owner, open **Connections**. Under **Requests for stock**, choose **RemnantRack**. If the page says requests are not switched on for this installation, your administrator registers RemnantRack first. If it says this organisation does not have RemnantRack, the product is not enabled for you in SmartFACT Accounts.

Choose the **Stockroom** its asks draw from, set **Hold reserved stock for (minutes)** (1,440 is one day), give a **Reason for this change** and choose **Connect RemnantRack**. A recent second factor is needed. The connection appears in **History** with your name and reason.

## Map the materials, with the length of one bar

RemnantRack lists its materials under **Items**, each with the unit `length`: one whole bar. Each one needs a StoresFlow item held in whole bars with exactly that unit, `length`, and no decimal places. An item held in metres cannot be mapped for RemnantRack: there is no single bar of it to issue.

For each material, choose the StoresFlow item and enter the **Length of one unit**, the length of one bar as you stock it, such as 6000 mm or 6 m. Write a reason and map it. RemnantRack offers new stock only for a mapped material, and only where one bar is long enough for the job. The length you enter travels with each issue: it is what RemnantRack expects, and the person there measures the bar when it arrives.

A material that is not mapped is never offered new stock. **Remove mapping** stops new asks for it; asks already open keep the item and length they were accepted with. Changing the length later never changes an ask already accepted.

## What happens to an ask here

Each ask is for one bar, for a job RemnantRack names. It arrives on **Requests** as a demand with the first reservation, as a refill does, and stores pick and issue it, or **Pick and issue** it in one step from the bin. If the item is lot-tracked, the lot taken travels with the bar to RemnantRack, so the offcut left after the cut stays traceable to it. Stores may close an ask short, with a reason, or cancel it; RemnantRack is told either way.

RemnantRack prints no stores paper of its own: its asks always use StoresFlow's pick document. Choose where it prints under **Pick documents**, as for RefillFlow. Without a destination nothing prints by itself, and stores print it from **Requests** with **Print here**.

## Pause or disconnect

Under **Change the connection**, choose **Paused** while stores cannot take new asks: RemnantRack keeps them and sends them again later. Choose **Disconnected** to stop new asks for good. Either way, asks already open are worked and reported back. To connect again after a disconnection, use **Connect RemnantRack**: the mappings are kept.

The Owner does not see stock on these pages: only material and item codes, names, units and lengths.
